Search results

The screw on the front sides of the gas tank that holds the panel in place. The nut that is molded into the tank is turning and I cannot remove the screw. Anyone have this problem and come up with a solution to stop the nut from turning. This is a 2007 Apex. May just leave it and peel the body...

Ground up the exhaust at end of Y pipes and start of silencer pipes. Looks like I lost the clamps and hanger under the grommets. Picks ate it up good:-( Any suggestions to make repairs? The y-pipes are SS. The Ti pipes failed a couple years back

Does anyone make oilite or nylatron bushings for the stabilizer bar? Replaced all the front and skid bushings, might as well get the last 2 done.

Well the y pipes finally gave up and need new ones. Anyone have suggestions on the best place to buy these expensive items? Looks like SS is the way to go from what I read on here.

My wife may give up her beloved Doo and I am trying to convince her to try the Vector. We do 200-250 mile a day ventures on groomed trails. She is worried that the Yammi is too heavy. She can't take the heavy steering on my Apex but she only weighs about 115 pounds. Any comments on this would...

http://www.sledmagazine.com/actions/pag ... snowmobile

Has Yamaha corrected the angle between high and low beam for 2010 Apex and does the Vector have the same issue? Several have tried to modify the High beam search light but have not read about any real success. I lowered my high beam to use as low beam and low beam lights up my skis. NOT A FIX.

Anyone have a suggestion on how to straighten bent handlebars? The right side is bent down about one inch after a minor mishap. :o|

Is there a copper washer any where besides the oil drain on the bottom of the motor? Changed oil and chaincase fluid and found a washer in the bottom of the waste oil. I put the copper washer on the bottom drain so, it would have to be the chaincase, oil reservoir, or an extra from some other...

The glue on the back of velcro is letting go. It holds the tank bag to the tunnel. Any suggestions on what to use to make it restick but posiibly remove it some day?

What are you running for carbides, length and brand, on your Simmon's skis? Are you satisfied with your set up?

Anybody looked at the new price for sleds posted on troy city garage? Insane!! I'll never spring order again. :drink:

I am putting in 144 studs down the center with double digger/single set up. Looking for hints on aligning the doubles up so there not crooked. Any tips learned from installing these?

ENJOY! http://www.snowest.com/gallery/video/707.wmv :4STroke: :nos

Finally had a chance to ride these 2 sleds back to back. I thought they were both excellent machines. One surprise I did have is the Attak did not hook up any quicker than the Apex. I would have guessed the Attak would be faster out of the hole. Both of them did throw a lot of snow out the back...

Anyone have a dealer in NH or close by that they can reccomend? Plaistow Power Sports is close by but service is beyond terrible.