Search results

Did you ever have any luck in finding these tees ? I also broke one. Having a great time trying to just find 1.

Did you ever get rid of these tees ? I too am trying to find one. I have looked for a while now and am getting a little frustrated that Yamaha does not have any replacement parts for the 04 RX1.

Thanks everyone for the priceless info on this site. My quest for the tees continues.

The brown tees with the bad boot as you say, is what I am looking for. How much are you asking for 1 or 2 of them ? feel free to send a PM.

Thank you for the help. However, 57 are for the air venting tubes. I actually am told it is 51 in this diagram . Although the picture does not show it as a tee. They are no longer available. i have also searched the Mikuni website and cannot find anything . This is the part needed.

Where did you find this diagram and how can I get the part # for the #6 Tees for the fuel lines ?

I was able to get two tees or pipes as they call them. $12 can. at the dealer. Part # 5DM-14396-10-00. Not too hard to replace. Just a bit of a pain. Update: This part # I suggested is for the air venting tubes and not the gas line tees. I am now stuck also trying to find some gas line...

I broke my fuel inlet pipe {Tee} There are just 2 long bolts holding the rails together. Not to hard to remove the bolts and wiggle the old tees out and replace. Just watch for the carb adjustment screw springs don't fall out. They are a bitch to get back in. Good luck.

When you say set the tension right, what exactly is the correct way ? I have two 2014 viper books. One says to finger tighten and then back off 1 1/2 turns. The other book (small book in the sled) says to only back off a 1/4 turn and tighten. Now those are huge differances. Which should I do