Search results

I've been searching all over too. Maybe I need to buy the service manual? I did try the reset with no luck; I checked the hand warmer switch to verify it was still working right and I was able to adjust the exup, so that should be correct. 21- Coolant temperature sensor- open or short detected...

Thank you for sucy a great reponse. It is from a 2012 APEX. I'm sorry if it wasn't clear. The codes you gave me for the Apex seem to be missing a couple as the numbers seem to skip. I have codes 45 and 64 that aren't on the sheet for some reason. The engine is running really well which is...

Okay, so every startup it will either throw or clear codes based on a diagnostic run when the key is turned. When would one use the “clearing” procedure that is outlined? Looks like I’m after answers for these: 45, 64, 85, 21, 22, 30, 42 Have you always swapped to other sleds or have you ever...

I got a guy swears it isn’t but he maybe was familiar with RX1. I installed the Genesis from the 2012 Apex w/ exup on my Gyrocopter. Had to modify Wire harness but all should be good. Runs like a top and a gyro has never seen such power to weight. But I’ve still got several codes and I can’t...

Is this different from the RX1? I would think after working on it, one could clear the codes and see what pops up again.

I tried this and saw someone else suggest that there is a 64 that it needs to be on to reset them, but on 62 nothing happens, and I don't have a 64. 2012 apex genesis motor. Any more tricks? I tested the handwarmer switch and it seems to be good according to the test meter.

Did you ever figure it out. I can't either on a 2012 Apex Genesis motor

Did you ever resolve this? I can't get it to clear on my 2012. Another user said "diag 64" was the place to clear it but I don't have that number available.

Same, I have "diag 62" but it doesn't reset codes. Another one said "diag 64" but I don't have a 64. I put this 2012 Genesis motor on a gyrocopter still using all the stock parts.