Search results

MASTER Sidewinder issues list and known fixes, no 5 look to top of page for Sidewinder stickies

Found it on US website I think, just search , Vinyl and Fabric Colors, looks like same stuff only doesn't have bilingual label.:rolleyes:

I don't know if it is canuk only, will get a pic of can up for you today.

Stain, it just says Dupli-Color on can, High performance Vinyl and Fabric Coating made by WWW.Duplicolor.com in the states. I used CHVP10600 Flat Black

Rattle can of Dupli-Color Vinyl and Fabric Coating.

And after hooking spring up, put a dab or so of high temp silicone on spring on chassis. When you take muffler out next time the spring stays put and sits up when it comes time to rehook. I hate looking for small parts in bellypan!

Looks good! Can't tell from pic but does r suspension have anti stab wheels? Looks like front of rail could use them.

Matt, will get you a better view tomorrow

top of light is 1 inch plus, sides are about 1/4 but tapers down. Under light the is a small gap and vertical grill for air.

The caliper reads .86 if it hard to read, the pic of the front measurement won't load but it is 1.2 straight down from the footrest pipe, the actual pipe itself. Any questions just post up.

Can get you some numbers tomorrow night.

Would like to see a side view, looks good.

This is why you put hose protectors on. High speed ice trail cruising at -30 ish . Had already cleaned the one side off when i Realized should take a pic

Mine is 13 XTX,

Not 100% sure if XTX has same length a arms but on my right side arm, on rear side of a arm from outside edge to inside edge, it is 56 CM.

Take a hair dryer, or heat gun if you have one, and heat it up a little and pull it off. Let us know

Something you might want to try, when you put the belt on, set it on top of rear clutch, as you push helix in gravity will assist belt going in between clutch faces and you twisting motion will naturally pull belt into sheaves. Easier than holding sheaves open and pushing belt up into them...

Just got a hood strap screw for a Phazer from dealer, a few bucks and works good.

Hows this?