Search results

I did the same thing, rewired the hand warmers and blew a bunch of fuses in about 50 feet. I now just use the warmers on 2 to 3 bars. Hands are nice and warm and fuses don't blow. Scott

Where exactly can I buy one?

Have you checked your needle and seat? My 2003 ran like crap and I also cleaned my carbs twice. 2nd time I noticed floats were sticking.. I lubed them up and it ran perfect. I did buy new ones and have since installed them and runs excellent. Cleaning your old ones might do the trick for a...

My 2003 RX1 jackshaft (Secondary Clutch Side) threads are screwed up. Anyone know what tap to buy to clean up these threads? I have a another used shaft but I really don't want to replace the shaft unless I have to. Scott

Mine ran like crap also when I started it up this fall. I cleaned the carbs and it started right up and it ran fine. Problem solved. Wrong!! After a month it ran like crap again. Off came the carbs a 2nd time. This time I noticed 2 of the needle and seats were stuck. I cleaned and used a...

I know this isn't the correct forum but I can't seem to login anywhere else on the TY forum. My GP292 oval racer tow sled, 1988 Sno Scoot, has an issue that I can't figure out. The motor will start on the 1st kick and run great with the choke on. Once you take the choke off, the engine...

My 2007 Phazer GT engine went down with 2000 miles on it. Cam chain let go and ruined the entire engine. The heads may be OK but the rest is junk. More bad news was my extended warranty ran out Nov. 30 2009. Yamaha said it was an "Unfortunate Incident" but won't stand behind it. They said...

My hands are finally hot!! So much that they melted my cheap Castle X gloves. I'll wear leather next time. I brought 5 fuses with me. I now have only 3. I better bring some more (my 03 always goes to max when I start it up). Thanks again for the tip!! Scott

I just rewired my 03 RX1 grips and put them on high because it was 8 below. In about 200 feet my motor quit like you turned off the key or hit the kill switch. I blew something but I haven't figured out what yet. What should I check first. Scott

I know the offset is different, I'll call Super Torquer and then post it here. I wore one out the last 2 years. It totally was shot for some reason. It came with a straight 42 and it worked awesome and I had to get another one. I picked up a fairly new one on Ebay and it comes with a...

I forgot the offset for the Heelclicker rigid secondary. It is different than the Yamaha offset. Anyone out there know? Riding in Hayward WI!! Scott

What's a good way to clean K&N Filters? I think mine are dirty as it won't hardly idle, but if I lift my hood the idle comes right back. Hot soap and water work? Scott

Mine would not start!! Changed the plugs ($14.00 a piece) and it started right up. However, changing the plugs was a pain in the a$$. I bet it took me around 2 hours. Next time probably 30 to 45 minutes. It sucked!! Scott

I have run them for 1 season and they work great after you get them dialed in. I run cams at 10800 so I had to grind away and ended up around 53 grams. Once I added the Rigid secondary the clutching really came together. Best setup by far and rarely get beat. Stays ahead of Mach Z's to 110...

What's the best way to increase ski pressure? It doesn't turn worth a hoot! Looked in the manual but doesn't say. Limiter strap? Scott

I just had my Phazer GT out on a snowy road. I brought with me my Garmin Etrex. I saw 92 MPH on speedo and 76.8 MPH on the GPS. The math is worse than my 03 RX1. I'm sorry to bring you the bad news. I'm sure we all knew deep down that it was too good to be true. The good news was that given...

I put on a "Ice Ripper" Ripsaw last year and loved it. I would not go back to studs again. Last time with studs on my RX1, wrecked the track, it blew and studs went thru my front cooler. Trashed a whole bunch of expensive parts. Go with the Ice Ripper, you won't be dissapointed. Scott

I geared down 2 teeth and bought a Hauck speed sheave. Top end is about the same. Definately helps. You will need a new chain however. Scott

I drove my girlfriends new GT also on Friday with about 2 inches of snow. This thing is fast off the line and is an absolute riot to drive. Went down a bumpy a trail and didn't feel any. It really does feel like a 600 or 700 down low. This is going to be my favorite trail sled when she's not...

I also just ran my GT on the grass. It surprised the heck out of me. This baby really has some low end. Pulled the skis way high and felt great. Power feels like a much bigger sled than a 500. Throttle response is unreal. This is going to turn some heads. Studded up this is going to...