Search results

Always tip it to the right side (oil tank side) when clearing the heat exchanger. I have 1500 miles on mine and when the light has come on the most is at higher sustained speeds when the temps are 20 deg and lower. The powder melts and starts freezing to the tube just below the heat exchanger...

Are you sure that when the clutch was reassembled that you put the spring tabs back into the right holes in the helix and the movable sheave. You also need to remember to pretension the clutch by rotating the movable sheave counter clockwise while holding the helix to just past the first ramp...

I ran 1400+ miles this season with out studs I did however plan on studing it and even put 96 holes in my track. But I think that this sled would be much improved with a 136" rail extension and track. Being a tall sled it should have a longer wheel base to improve handling. So I am planning to...

Unload yor sled first start it then put your gear on and by the time you have your suit gloves and helmet on it will be ready to be run hard. It is normal for this sled to fast idle 2500 or a little above for a few minutes then it will settle back to between 1700 and 1800rpm when warm. Its a...

If it has the right belt (check your part number)installed it should be flush to about 1/16" above the sheaves. To adjust the deflection you have to remove the secondary remove the snap ring and split the clutch. It comes with two shims on the shaft from the factory and you generally can not...

I like my front end to hook up so I threw my stock runners out after 90 miles and replaced them with 8" Woodys. It was a tremendous improvement but the limiter strap also needed to be shortened and the center shock softened to really improve the handling. The Phazer is not a sit and point sled...