Search results

Another question, my BOV actually chatters when I rap the throttle a little from idle. You can see the piston in the BOV chatter or shutter real quickly. what is that. Also should my BOV only open after a quick let off of full throttle. I have the turbo smart billet BOV that boondocker offers...

I just installed one on my apex turbo application-----what a joke. Its been nothing but a nightmare trying to get this sled to run right. I'm at the point now where it will run up to 10,500 rpms then it craps out on me. Boondocker boxes----not a good choice in my opinion. Outlaw motorsports...

MSD pump I was talking with a sled shop here in Colorado and they are removing the MSD from their apex's. At these elevations (10,000 and better) our fuel requirements are much less, so our turbos can utilize just the stock pump up to 15 lbs. After that well you need the fuel boost. I'll be...

Just installed boondocker gt28 turbo kit on my apex. Running at elevations of 9000 to 11500 ft and cannot--cannot get it to run. Off idle is rough, mid range pulls like a son of a gun and 9000 rpm and beyond gets so lean the motor just about shuts off. On top of that my boost sticks at 12 and...

Since were on the subject of boost and horsepower. Here is another case!! Alot of these Sled builders have told me --don't go over 15lbs of boost on a stock apex motor without rods and pistons. Well if they have a specific high horsepower number attached to that 15lbs ---- well than most...

Boondocker got back with me. Turns out they had some yahoo wire up the harness and he put some wires on backwards. It should work fine--we'll see Friday. Does anyone have some base settings for the EFI box I can start out with for 12lbs of boost. Running at elevations of 9500 to 11500 ft...

Boondockers new kit has no flex joint--it has a slip joint. Maybe you can try that header. You don't need to bend the steering either----that was changed too. As for heat and warping, try header wrap ---if you haven't done it already. Check it after every season ---sometimes that stuff falls...

Just installed my boondocker turbo---everything went well except for the garbage EFI box pulling an Injector fault on #1. Anyone out there have this problem. Should I just junk the box and get an Attitude or Pure Logic. Boondocker doesn't seem to want to get off their butts and help. They keep...