yamadooski
Extreme
This past weekend I tried to put 4 inch shaper bars on the outside and 6 inch in the middle. The 4 inchers went in pretty well but are a little higher than stock. The 6 inchers would not seat properly in the ski. Any hints on how to get them to go into the slot?
RTX DUDE
Expert
- Joined
- Mar 10, 2006
- Messages
- 209
- Reaction score
- 0
- Points
- 376
- Location
- townsend Wisconsin
- Website
- www.northwoodsrealty.net
some help
I run 6" stud boy shapers in the center only. I give them a wack with a rubber malet and they seat just fine. Stock 6" bars on the outers. I think the shapers on the outers are wayyyyyyyyyyyyy to much man. My opinion.
I run 6" stud boy shapers in the center only. I give them a wack with a rubber malet and they seat just fine. Stock 6" bars on the outers. I think the shapers on the outers are wayyyyyyyyyyyyy to much man. My opinion.
BA APEX
Expert
where is a good place to get a deal on the pilot carbides. I want to get 6" for the centers & maybe leave the stock 4 on the outsides.
RTX DUDE
Expert
- Joined
- Mar 10, 2006
- Messages
- 209
- Reaction score
- 0
- Points
- 376
- Location
- townsend Wisconsin
- Website
- www.northwoodsrealty.net
shapers
I go right to my Yammi doo dealer and buy them. Don't see much of a point to try to save 2 bucks.
Good luck
I go right to my Yammi doo dealer and buy them. Don't see much of a point to try to save 2 bucks.
Good luck
ROCKERDAN
OCD Sledhead
- Joined
- Oct 8, 2005
- Messages
- 7,496
- Reaction score
- 3,609
- Points
- 2,003
- Location
- Huntsville Ontario & Niagara NY
- Country
- Other
- Snowmobile
- '18 RTX 50th "Winder"
I just leave the worn stock DOO 4 inchers for outsides and stick 6" shapers on centers.....outsides will never wear down.
yeah they didnt fit exactly perfect but they will go on.....handling is awesome.
Dan
yeah they didnt fit exactly perfect but they will go on.....handling is awesome.
Dan
Similar threads
