k9RX1
Newbie
I just purchased a Powermadd left hand throttle. Put it on my 2003 RX 1. I had to take the locking nut off the carb side of the original cable (cable to tight). I got it mounted and everything seems to work fine. I start it up and occasionally the sled bogs and wont go (back fires). It happens more frequently when left hand throttle is used. I am guessing there is a throttle safety switch that needs to be disabled. Anyone have any suggestions on how to do this and how they did it. Did anyone elso have this problem.
Thanks
k9RX1
Thanks
k9RX1
rx1mtn
Expert
Yes I had this same problem, you have to disconnect the TORS. Also I had a problem with the throttle after about 600 miles, my throttle stuck wide open. I had to disconnect it.
Jonny Rocket
TY 4 Stroke Guru
- Joined
- Apr 13, 2003
- Messages
- 766
- Reaction score
- 1
- Points
- 893
- Location
- Colville, Washington
- Country
- USA
- Snowmobile
- 2008 MXC boosted Nitro
It is definitely the TORS, but I don't know if I would disconnect it. I had the same problem when I put a 1" handlebar riser on. I had to push the handlebars forward to fix the problem. I was thinking of disconnecting the TORS but am glad I didn't. My throttle was wide open because the thottle cable was getting pulled. If I would have disconnected the TORS and started it, the sled would have done very bad things to my shop. I would try to fix the problem rather than disconnect the TORS. It is there for a reason.
J
J
