Recent content by bigdaddyjak

Everything in chaincase looks good, shafts r tight, no wobble . But when I start it up, start Erving it up the belt is slipping, winds up enough that motor cuts out, like a rev limiter. Belt is pretty worn, I got a new belt, put it on, and it's very loose. I take the slack out of the belt...

Or even a fine thread metric!!!

Sled has M10 on it, so trying to find the correct bolt size is a pain in the #*$&@!! Is it a 10 mm bolt , a 3/8 bolt or a 3/8 fine?? There a little buggered up I can run a tap in, but I'm not sure what size , sae or metric!

Correct ! At least that's what I have found! I drive it once last yr, that was to move it in the barn when the season was over, and I noticed it! Surprised she didn't notice anything!!! Looks like there is an aluminum bushing on each end of the shaft, then just a bolt and washer bolt on from the...

Thanks for suggesting to check out skid!!! Sometimes it's easy to overlook the obvious ! I raised it up, n noticed the skid moved rather easy, there r no bolts holding the front pivot arm to sled!!

quote="ghost rider"] Parking brake engaged ? That's what it seemed like! But not the problem!

Had a chance to mess with it, everything in chaincase looks ok, chain was a bit loose, nothing big. Fired it up, rev it up, watching the belt, it is not engaging on secondary , when it does, the rear suspension raises up, and extends, and it seems like it's locking up , like it's all bound...

Thanks guys, I haven't had time to get into it yet, hopefully this weekend. I will check spring, and jack shaft and bearings!! Again, thanks!!

My wife has an 04 RX1. Last year I was putting it away at the end of the riding season, and I noticed a clunk when I gave it gas(when clutch engaged). I moved it very little as when I revved it for clutch to engage it would clunk, and then it would slip, I haven't messed with it yet, but I think...

just got an 04 RX 1 with M10. runs great rides like sh!t ! it is all over the place on the trails, it just seems like a bear to control. From what I understand and have read(i have been reading on here every day about it) it sounds as if i need to transfer weight off from the skis, as too much...