Recent content by Dannel94

Im not entirely sure, they just said they might as well check the gear when the sled was on the lift and since its a weak point so they opened it up and found metal pieces and that the top gear was done.

The dealer installed heavier weights and now it runs as it should. They also noticed that i had stripped the top gear so they changed the gear and chain for free.

I will keep my SW for a long time but after that i'll probably pick up a Lynx 900 ace turbo

They are a specialized Yamaha dealership with their own workshop so i think they know what they are doing. I checked a clip from today and noticed that it pops when i let off the throttle, i thought it was on acceleration before but now im not so sure. I uploaded it to Youtube so you can watch...

Dealership said it was fine to ride but not too hard until they looked at it. I reset my "max rpm" and went for a ride, got a bang and looked at it and it was at 9480rpm so im hitting the rev limiter.

It was tuned from the previous owner. Bought it from a Yamaha dealership, guess they will have to look at it.. Should be ok to ride as long as I stay away from WOT tho, right?

Hi, just bought my first sidewinder today. Noticed that when i give it some gas (80-100% throttle) it will make a loud pop from the exhaust. Only once. If i let throttle go and give it some gas again it will pop again. Also smelled some burned oil/plastic from it once. Im leaving it to the...

I just called and said if they could include a cold air filter in the deal i'll take it, so tomorrow im getting the 2020! It feels Nice with three months warranty. The last 4 stroke Yamaha i bought blew up after riding for 10 minutes so hoping that i have better luck with this one lol

Hi! Im about to buy my first sidewinder. Im sick of the suspension on my Skidoo MXZ 600 SDI from 2008 and saw a Sidewinder BTX SE for 6000€ for sale and thougt, damn thats cheap, and It looked like its in Great condition. I went away and test rode another sidewinder from a dealer close by and...

Ok so i checked my cables where it had rubbed against the frame behind clutch and opened it up and taped the cables seperatly with electric tape. Then I measured resistance from the ECU to coils and looked like it was fine. Tried to start it but it just clicked, put a wrench between start relay...

Ok thanks. Checked 12v connection and it had some green stuff so I cleaned it. I was thinking, it has started to act up when I try to start it now (at the same time the rest of the problems), the relay clicks but wont turn over the engine. This started at the same time as the afr went crazy...

Yes fresh premium 98(europe, sweden) fuel Plugs gapped at 0.20 (0.5mm) Wierd since the sensor and gauge is only 2 weeks old, maybe the soot killed it? Will check power and ground to it.

Did you find the fault? Having a similar problem.

Hi, bought a Nytro -09 MCX 270 for 4 weeks ago, grenaded the engine as soon as i got home. Put a new engine in and it was running awesome for about 1 week. One morning i was going for a ride and started it up but it was only running on 2 cylinders so i checked fault codes and got a code...

Hi. Bought a nytro mcx 270 2 weeks ago, it threw a rod as soon as I got home. Now I have changed to a new(sitting for 7 years) engine but the engine oil light is on even tho the level is good. (Over h mark, could too much oil make the light go on?) Checked with the dipstick Not screwed in. I...