• We are no longer supporting TapaTalk as a mobile app for our sites. The TapaTalk App has many issues with speed on our server as well as security holes that leave us vulnerable to attacks and spammers.

Recent content by Hammer Down

  1. H

    Closed loop - poor fuel mileage

    Maybe unplug the 02 sensor and run it? This should default to no closed loop and compare. You will see SD-24 on dash but that okay. maybe O2 sensor acting flakey. I had three go bad on mine.
  2. H

    O2 sensor part# for closed loop

    https://www.amazon.com/Replacement-Replaces-0258017025-Compatible-Wideband/dp/B07M7X6J6B/ref=sr_1_5?crid=1FKGOYSYC2OVL&keywords=0258017025&qid=1705935573&sprefix=0258017025%2Caps%2C72&sr=8-5&th=1
  3. H

    Looking for help suggestions next steps troubleshooting

    Where is it located and how big of a job to replace?
  4. H

    Looking for help suggestions next steps troubleshooting

    Very helpful thanks ! I will check resistance. If you have any tips on locating the harness connector that would be great.
  5. H

    Looking for help suggestions next steps troubleshooting

    Hi turbo flash i turn over fine starter motor engages and can hear fuel pump. I think the winder has a different system than the wheeler shown in the video.
  6. H

    Looking for help suggestions next steps troubleshooting

    All 2017 SW with TD tune with close loop with 15K mi. I recently added clutch weight due to slightly over rev. Note I may have turned clutch CW when adding weight not sure. After weight was added did small run around field but it was not a long enough runway test fully but seemed fine nearest I...
  7. H

    Performance Stud Stars

    So far so good but only 100 mi
  8. H

    Yamaha clutch weight?tuned sled

    Nope over rev unless you add weight been there done that!
  9. H

    O2 sensor part# for closed loop

    I think it’s SD-24 not 5 my module says Lamda to CAN on it I use it with Dash flash. I hope this helps
  10. H

    O2 sensor part# for closed loop

    Nothing but headaches for me and when working correctly no noticeable difference seat of the pant. Wish I never went that route. Thinking about plugging the bing revert back to none closed loop tune. ordered up another sensor going to give it one last go. Took me a couple hours to figure my...
  11. H

    O2 sensor part# for closed loop

    Hi and thank! My riding partner has the same set-up and mounting location with no issues. I am 95% certain that they are mounted in the same spot but will verify and we use the same fuel. I doubt MMT we use pump gas typically 90-94 octane. From some research MMT is banned in the US and sense...
  12. H

    O2 sensor part# for closed loop

    All I have what I believe is a O2 sensor failure that is used with the TD closed loop set-up. This is will be my second failure. At idle AFR dash reading is 14.9 then jumps around 20, 30, 40, ….. Looking for Robust or equivalent replacement part# and if handy recommend place to purchase. Thanks!
  13. H

    '19 SRX coolant bubbling after ride

    I have a 17 and ride with two others Winders. I was experiencing a lot of gurgling after shutdown while the other in My group had little no gurgling. the fix was to add more coolant. I had to pull the panels and add it direct to the engine fill not the reservoir. Problem fixed. My Winder has 14K...
  14. H

    High mileage thread

    drive Shafts, upper gears, reverse actuators, fuel pumps, shocks, wheels, tri-hubs, 4 wheel kits, tracks, many bearings, chains and gears. Relays, handwarmer, cross shaft, many idler wheels….


Back
Top