Recent content by jeffgilbert

I get what you are saying i remember setting deflection on older cats with washers on the inside of the sheaves. I seen the float that was there when fooling with the aligment bar. Is it beneficial to have a few mm of float or to have it solid?

i was aligning mine with the bar and when i removed the circlip and bolted it down i was bang on. I figured the secondary bolted down against the bearing would be fine but i was advised from a few including hurricane not to do that but to go get the shaft machined as well as the aluminum plug...

i just ordered one for my 19 btx. the sled has 0 miles on it and first thing I noticed was that the center spring was wound all the way and still had all the weight on the skis compared to me old viper rtx le 1.7

My 19 BTX LE has the same helix. according the the ink mark and the spec sheet.

the highest pump gas i have available is 91.

so you can see close to 170kph? are you tuned? did you find the stock front end set at the narrow setting to wide for off trail? i have the same sled spring ordered and i was wondering if it will be too wide thanks

get a heavier front track spring take the weight right off the front end

so the max spool 17 is a 91 octane tune? has anyone seen any knock with this running 91 right from the pump?

i blew my gates belt at 3-2 i put a new 8jp on and set at 3-1 no ssues i may put it back to 2-3 and try with the jp

I'm running the gates 8jp right now its supper grapy but it gets a bit hot. I just piked up a new Yamaha 8jp to try too i have always had he best performance out of 8jp belt even if its dirty and don't lat as long but they are only like $110 cad so if i use 2 a year no biggie

i have mine at 2-3 right now it was a bit warm i was told 3-1 for trail and 3-2 for off trail im running a 2" track this year and 21/41 gears mt rpms re a bit hiht on launch but i am using a reverse helix 40/46

what wrap did you have yours set to ? I am running the same helix and belt and spring

Thanks Dan!

i have the tpi orange in my turbo viper wrapped at 3-2 with a 40/46 reverse helix i did notice hot belt do you think 3-1 would help it with the heat

i picked up the new starter relay but haven't installed it yet what is the 18 relay suppose to help with? lower voltage drop or better internals?