Recent content by Remedy17

Scratch that, none of the washers were large engough to fit on the engine side so for now it's staying the way I found it.

So, it turns out without any washers on the engine side its at about 14.8 mm's offset. I think I'm going to flip the 0.5 mm washer from the front side giving me about 15.3 mm's offset unless some advises otherwise.

Thanks for the info. I'm going to put it on this morning the way it was, check the offset and make adjustments from there.

I have a new to me 2012 RS Vector and today I removed the secondary clutch to clean it and I was suprised to find that all of the shaft spacing washers were on the bolt head side of the clutch. There are (3) 1mm thick washers and (1) 0.5 mm thick washer. When I look at the parts diagram it...