Recent content by rws

you probably meant to say to provide power "from" the key switch and not "to" the switch tying the red/vlt and red/grn does not provide power to the key switch the key switch is powered by a red/wht wire (batt +) from the fuse block when the key is turned the red/wht and a red/vlt wire are...

the board resized the above picture here's a .pdf should be bigger/clearer https://www.mediafire.com/?drto96mjmlbzabd

get .pdf file in post below

2014 Arctic Cat 7000....looks to be the same color code as the Viper

The Viper has a Marinco 12v locking receptacle for powering your 12 VDC accessories and when matched with a 12v locking plug it will prevent power disconnects from vibration typical with regular style rec/plugs. Notice the plug's ground clips are squared off which when lined up with the arrows...

In the last 5 seasons I've put on 35,000 miles on two different sleds with the GPS mounted in the same position...totaled one of the sleds hitting a pressure ridge...the GPS was destroyed from rolling not me hitting it. I don't see much difference from your chest hitting the top of the...

no

This is on an AC XF....I'm sure the Viper has a similer handlebar/riser setup. I fabricated a plate and bolted it on top of the handlebar clamp using the two top bolt holes. I also mounted a mini fuse block under the right side panel to provide an always hot power source for my GPS, electric...

I made a plate to mount on top of the handlebar clamps then used RAM balls, a short arm and a Garmin AMPS to mount my Montana. I also have it wired/fused directly to the battery for always on power.

When you are navigating a route does it do it on the trails or is it trying to navigate on roads? If you have the road map disabled in map setup it will only navigate trails. You unit is evidently set up on a route that is not in the vicinity of where you are currently riding and is...

it's a WiFi remote for GoPro Hero 2

determine where you want the GPS for best view then buy the appropriate arm/balls/plate this is the AMPS mount https://buy.garmin.com/shop/shop.do?pID=89575

on my new 2013 XF1100...using a Garmin Montana AMPS mount hardwired to sled for always on power.

updated Ontario GPS trail map http://ontarioconditions.com/forums/ind ... -versions/