Recent content by **sj**

Did you score one?

and pro4 also?

I understand what you are saying... But, I think you should convert YOUR measurements to how Yamaha measures to maintain standardization...

I think you should measure with straight edges at rear of drive and front of driver for a more exact measurement

Little missing information from the Dyno run This is actually not a 24’ with the meth injection, but a 23’ You can draw your own conclusions as to the reduction of octane needed for a tune as the math is introduced.. Tuners will surely be able to adjust the meth will bigger power tunes… Just...

825 is about 1/8” narrower and about 1/2” shorter????

Thanks! 829 belt vs 825?

Peek to peek ????

I’m thinking aluminum and aluminum too should dis similar metal reaction.. and there’s no real load to be concerned with ..

What size rivnuts and screws

What about tapp / pro 4 secondary offset …anyone have this combo?

What was the setup and where did you go/end up from there

That track never came on a23 to my knowledge

for cracked cases...Anthony Kolenko (sw mich) welds the damaged cases fyi