Recent content by stuffum07

Yep fairly easy to do and i ran a separate ground wire to chassis ground for each ground block as well. Soldered them all together at each junction.

No never looked bad but when i made a jumper basically clamp on ground and go through and touch each ground when you pull the black caps off. See if you hear system fully power up. You can also test this with 12 volt dc test light. It will be very bright when you find the right ground

Thanks again

Any update on these. I am thinking about trying some as well on my nytro

Ended up getting it thanks to you guys. Was definitely a grounding issue. Only took care of one of them ground blocks so far. I am going to tear the sled down again and cut them all out and solder together. I cut the one out right above the secondary clutch. Actually. I tested with test...

Got another good question. There are many lil junction blocks in the harness. Some are lil black ones, others are clear or whitish with black cover on them. All are different color wires. Im betting some of these are only power wire junctions. Any idea which junctions are actually the ground...

I'm going to go ahead and do that then. Thank you

Also have you personally seen issues with these going bad causing similiar issues. When I went through mine I was in debate whether I should go ahead and do it just to eliminate it, but I never did. Wasnt quite sure which route to go as for joining all of them.

No Negative. All the ones in the white plastic lil Junctions. I did go through them and did not see any that were burnt up or anything.. But what are people using to connect together After they cut out junction box?? Soderling all together and electrical tape??? or what's recommended??

Yes I have. I have replaced all my relays with new red solid state updated ones. I've went through about every connection on sled made sure There was no green oxidation and if There was I sanded and applied noox/ or dielectric grease. The spot you are referring to actually did have very little...

Has anybody ever experienced this. Does not happen all of the time. But when it does sled shuts down, display flashes er-1 fault and fuel pump is clicking. I tested fuel pump due to thinking it was issue because sled would turn over fine just no fire. So I do know when this happens. Sled is...

Just curious looking to buy new skis this year for my sled. Wandering if anybody has tried the new Slydog Attack skis for there Nytro. I've ran the original Powderhounds for many years now. Always have been a really good ski. Just going different color scheme this year. Didnt know weather to...

Anybody have any experience with the new 8" powderhounds. I currently have the 7" powderhounds on my xtx. I like them but would like to see if there are better options for 40/60 riding. Flotation is great off trail. Steering effort is pretty hard for on trail riding. I've seen mixed reviews...

Okay thanks guys

Hey where did you end up purchasing from. I have been looking everywhere for the black 200 model boards for fx nytro xtx. Not having any luck