Recent content by triplel

Thanks for the help guys. TripleL

Does anyone know if a 2010 Nytro MTX 162" skid will bolt into a 2009 Nytro MTX 153" sled? I know therey are different skids, just wondering if the mounts are the same. Local dealer no help !!!!!!!!

Thanks Zakre Your reply was technically consistent with the previous 177.

2009 Nytro MTX, 500 km, stock. Does anyone know what the roller pin(collar) OD is supposed to be? The roller bushing ID is supposed to be .357" new, .366" max wear. I cannot find any dimensions for the pin. Reason I'm asking is that fr!*%#in rattling noise in my clutch when it's idling...

2009 Nytro MTX, 500 km, stock. Does anyone know what the roller pin(collar) OD is supposed to be? The roller bushing ID is supposed to be .357" new, .366" max wear. I cannot find any dimensions for the pin. Reason I'm asking is that fr!*%#in rattling noise in my clutch when it's idling is...

Re: too many variables to answer based upon what you posted. Mountain riding, about a foot of fresh powder, 6-8500' elevation, I weigh 200 lbs, sled is stock.

I've been reading through all the clutching info on this forum and have not seen anyone say they've tried what Yamaha suggests. Are their recomended set-ups to general???? I'm riding a stock 2009 Nytro MTX. I've been reading through the 2009 FX10MTRY, and the 2010 FX10M53SZ / 62SZ tuning...

Maybe it's not clutching I was reading another post over on the Nytro Mountain forum and they were talking about a stumble or a stutter or ???? at a low throttle position. Have you heard anything like that? Again, stock sled. TripleL

I'm riding a stock 2009 Nytro MTX at 5-6000'. I'm using the stock 8FS00 weights with .8g in outer hole, 3.1g in both the center and inner hole. I've got a blue-brown-blue primary spring and am running 20/40 gears. Engagement is 33-3400. Everthing else is stock setting & spec. Sled works...