Recent content by yamaha06

Thanks for the reassurance, guys. Now I just have to purchase parts to repair all the cosmetic damage.

Haven't had much time to ride my 2023 SRX due to the wife having a baby. We had finally gotten enough snow around my area to go out riding, I managed to put a few hundred KM on it Saturday (Bought it as a new left over from the dealership last year) Yesterday I took my dad out and let him ride...

I have a 2017 Sidewinder LTX LE and a 2023 SRX - I have a Hurricane offset bar that I used on both sleds - the clutch offset for my 2017 was 58mm and my 2023 SRX offset was 59.4mm

Did you end up not using those big washers? When I installed mine I never used them since the instructions didn’t mention anything about them. I wasn’t sure what they were used for.

Sent you a PM

Well the dealership said the charge tubes are on back order until the end of March. I am supposed to be going on a sled trip in 10 days, I don't think the cracks are fully through the tube, but I imagine it's probably not advisable to drive the sled with the cracks, it probably throws some kind...

Has anyone had issues with the stock charge tubes cracking? I have a 2017 with 17,000km on it and they still look like new. My 2023 SRX has 4km on it and the charge tubes are all cracked. I would assume this would be covered under warranty.

Tonight I was able to get around to checking my clutch offset on my 23 SRX. The offset was 62.43mm, I removed the shim and was at 60.4mm I used my Hurricane alignment bar and there was roughly 1mm of play between the gauge and the sheave so I could probably machine 1mm off my secondary and be...

Running snowtrackers on the 2023, there is a 5mm shim with my stryke skis. Did you guys run the shim still or remove it?

I’m in the process of doing a track swap on my 23 SRX and noticed the limiter straps are in the third hole from the top, is this a good place to be starting or are most running in the second hole? I know the suspension and everything is different on the SRX, on my LTX LE the limiter strap is...

That would work, I can’t seem to locate it on Amazon. I found some that says for headlights but people were saying it was completely clear. I’ll have to search a bit more and see what I can come up with. Thanks!

Where did you end up getting your film? The tunnel is roughly 15" wide and I am having a hard time locating some film.

I was thinking of putting some clear film on my tunnel to help protect it from the tunnel bag. Has anyone had any luck with installing the clear film over the rivets in the tunnel? I would think it would be difficult to install but still looking at giving it a shot.

Hey guys, are the shims .5mm thick? I remember years ago making my own this for the chaincase but I cannot remember what thickness was and after doing some reading it looks like possibly .5mm but other post are showing possibly less. Thanks

I was just looking at the Stryke ski's on my 13 SRX, the dealer put the 5mm shim at the front of the spindle, should it not be placed at the rear of the spindle so the tips of the ski tip up rather than point down when the skis are suspended?