Search results

I said I would report back on my testing results for this year. Drag N Fly results with white primary spring and stock helix. First run. 3.1 heel 3.8 center 3.3 tip 0 od First Day of testing. 200 ft 3.46 3.54 500 ft 6.21 6.28 Pulling 10300 climbing to 10700-750...

drag n fly Yes this is the bolt too. I have different gram washers that i bought from hardware store so I could fine tune better. This is also with the black primary spring. The best way to set it up is start out with this wieght placement and do the test I stated in the previous post. If your...

drag nfly You are running way to high rpms out of the hole. Go back to 3-3 in secondary and start loading up the weights. As of right now I am running 3.0 heel 3.9 center 4.3 tip 4.4 od. You want to come out of the hole after slight initial overrev to settle in at about 10,200 and slowly climb...

drag n fly Scotts setup was a starting point. I added quite a bit of weight more to certain holes. Also going to 6-1 from 3-3 will raise your rpms. Saturday I will post all my testing results to date. From my testing in a 1/4 or less drag race you want to pull 10700 or less. Anything higher was...

Been working some longer hours but was able to get some testing in the other morning before work. My hauck setup was the fastest to date until I tried the black heel clicker spring that Scott at Boss performance said to try. Well to my surprise this setup rocked. I tried alot of different...

drag n fly Just got testing a new setup with the black primary heel clicker spring. All I can say this is the best setup to date. I tried all different setups with the white spring and the best one was still two lengths slower and 1-2 mph slower in a 1000 ft. than my hauck setup. Did try a...

drag n fly What are you pulling for rpms. Contrary to what some say I tested pulling them 10300 out of the hole climbing to 10800 versus 10300 climbing to 10500-600 and climbing to 10500-600 was actually guicker in a 1000 ft to a 1/4 mile. Thanks Kurt

drag n fly From my testing the drag n fly does not seem to pull the top end like the stock weights or haucks vp weights. Now this was in a 1/4 mile run and every setup with the drag n fly it was consistently 2 mph slower in this distance and seemed like it was not climbing like the other...

top end The stock weights should pull excellent top end. I have done tons of testing now with four different weights. And hauck and stock weights seem to have the best top end. And this is at 10500 -10600. I will post my results later but these weights really pull on top. Tried Dalton and drag...

cracked rails Mine cracked too right by the rear mounting bolts for the rear suspension. Took to a local shop and had it welded and a reinforcement plate put in for fifty dollars. Trust me it will never crack again. Very simple fix for a good machine shop.

Bad day at the testing track. Was dialing in a new setup from hauck compared to my drag n fly and the old ripsaw let a stud hang loose and ripped a nice hole in my front radiator. Thinking of getting a cobra track how do these compare to the ripsaw. My final testing was almost complete when it...

I have a 2007 attak gt. Need part # for the weights and the rivets and also the primary spring. I looked up on the internet but they list a lot of different weights and springs. Thanks for the help.