Search results

I have the same sled same fluctuating ISC issue when cold. Did you figure it out?

The idle speed changes fast for about 3 secs then slow for about 3 seconds alternating fast slow fast slow until it warms up. It doesn't maintain fast idle when cold. It's got low miles around 5K. I got it used. Always done it.

I've had this sled for a few years and it has always had a temperature related idle problem. When cold it will cycle from fast idle to a low idle about every 5 seconds. High-low-high-low etc. until it warms up. When the sled is warmed up it idles perfectly. However when cold when it drops the...

Thanks for the tip I'll check them. I did some major work at 10,000 mi including replacing all loose rivets and adding rivets where I found the loose ones and yes that area under the tank had a bunch of loose ones. That muffler cracked at the y and got welded at the Yamaha dealer in Alma, QC a...

It's not charging the battery only getting 12.05V at 5,000 rpm with accessories off. Going by the service manual resistance is too high. Not sure about the voltage but assume the three phases ought to have equal output?

Fixing my 2006 @ 17,000 mi. not charging added too many watts? Heated seat, alarm system, heated phone cradle, Silverstar Ultras white-white all 0.6 ohms s/b around .15-.24? AC output 18/14/13V Ordered a stator and gasket hopefully fixes it Also used muffler, 3rd one - broke clean at the y to...

I have about 2,500 mi on my Ice Ripper had 192 studs on the stock track, honestly I think it hooks just as hard as the studded track, I will never buy another stud. The track is still in perfect condition and I don't baby it. 06 Apex RTX Sent from my RCT6303W87DK using Tapatalk

This one works great Sent from my D6708 using Tapatalk

Had the same problem threads were pulled on one of the bolts that clamp the y-pipe to muffler. Replaced the clamps and all good. They are easy to strip and it doesn't always leak. Sent from my D6708 using Tapatalk

Dupont Sent from my D6708 using Tapatalk

the 07 works. I just changed mine yesterday (06 RTX)

I tack welded a nut to a c-clamp and got the bearing out that way. 15 min job. Just need something on the clamp to push it out of the bore to where you can grab it.

I've got extra y-pipes L&R if you're interested shoot me a pm.

BS. Make the bars much colder and damage the stator?!?!?! It's one or the other, stop confusing people. The mod can't be applied to 07 because it is already there via the sub-lead. There is nothing to reverse. It is already been done by the factory. Take another look at the two...

This will help those that are asking for help via PM not to offend any Yamaheater lovers who would rather spend $175

If you're comfortable with wiring you can just rewire to series from parallel. I took the pins out of the connectors with a paper clip and moved the wires because I didn't want to cut/spice. The bars will be HOTT!! afterwards you will never need any setting over 50%. You should have an unused...

X2

I'll work with ya if you only need one, I was desperate last year and bought 2 sets Ti and SS because of a shipping delay, I put the SS on because I think the Ti although very light weight is somewhat brittle, personally I wouldn't try to patch it, with the damage I saw I don't think you'll be...

I've got an extra set of Ti y-pipes in very good condition (flanges are perfect no cracks) you can have the pipes and new donuts still in the package for $300 if you're interested.