Search results

Any body do an ez ryde skid in nytro? Looking for any info on install or pictures i have no brackets or measurements for a 159 I do have 153 measurements. Thanks

Any body have any information on installing a ez ryde in 08 nytro i do not have the ez ryde brackets and the rear measurements i have are not lining up. I have 2 skids 153 & 159 thank any help is appreciated

Does anybody still make the copper exhaust gaskets for the vector in Canada if not any where else thank you

my 08 nytro is still showing power on the dash with the key off. i went for a ride today & came home shut sled off & went into the house, came out later to put sled in garage & the dash was all powered up with out the key in it so i put key in started sled then shut it off everything went out...

how do you stop these sleds from digging holes instead of pulling away. rode today every time i pulled away on a slope it would just big a big hole & my buddies sleds would have no problems polaris,cat & doo they would just drive away. it has a 156 camo extreme track & 8lbs boost but will not...

can you take out the temperature light sending unit in the thermostat housing & put in one for a digital gauge, i have two gauges sitting on my shelf & would like to install on my nytro thanks.

i have a ulmer turbo kit & would like to run the exhaust under the tunnel, will the mbrp muffler i have fit or is there something that works better thanks

how do you tell which springs are in the rear of the skid, can you measure them. the part numbers are worn off.i have a 08 nytro with 09 skid in it & it sits quiet low even with them adjusted to hard the transfer rods are just about bottomed out & that's before i get on it. my 08 skid sits...

does anybody have a picture of one of these bags on a nytro would like to see how big it is & how it fits thanks

anybody read about this, it is on snowest site braniX Performance www.brani.org if not here it is http://www.snowestonline.com/forum/atta ... 1312449477

i rode the sled last sunday it ran fine then put it in garage tryed to start it today a week later & code 12 flashing will not turn over i know it is the crankshaft position sensor just looking to see if anybody had this happen to them & what was done to fix it thanks

i just piched up my first 4 stroke 08 nytro mtx it came with a power commander & after market exhaust does anybody have a map for it there is none on there wed site i don't no to much about the power commander so i don't no if it is even working so any help would be appreciated thanks.one more...