Search results

its the cranksensor the only thing in common with all three coils for codes 33 34 35 windings will work intermitently on and off and it is possible to buy a new sensor and it is NFG they are small cooper winding and can break very easy

codes were in diag 33 34 35 everytime i punched throttle machine would quit code would appear again i would clear them and after machine would quit they would come back some times machine would not start for 5 minutes or so i think the winding in the cranksensor would cool down and make...

it was crank sensor

finally found the cause for 33 34 35 CRANK SENSOR after i spend 430 at dealer for nothing and then bought a complete wiring harness it was crank senor paid 118 CND :-o :-o

by pass the tors plug white into black and black into white wires by headlight single black single whit if it still does not run right it is not tors

crankshaft sensor was breaking down at high loads all good now!

Hey bought brand new wiring harness and a crankshaft senor tried sensor first it worked machine ran fine code 33 34 35 gone for good had this machine in dealer bench checked the crank senor and said it was fine but under load it was not fine i spend 430 bucks at a dealer for not a thing bought...

ya thought it was gone but found cororrded wires all green and black falling apart ordered complete wiring harness

I tired to pull out my wiring harness found a pile of green corroded wires and plugs try to solder up but have to order new harness

try by passing tors i did not get code 84 only got 33 34 35 machine sometimes would quit i by passes tors at both ends and have not had a problem with those codes since or any others there are two wires on left side a single black and a single white plug black into white at top and black into...

I by passed tors and no more codes all good throttle response is much better no bog anytime when u hit it

Have the same sled was getting no codes just flash light and would reset before i got read codes I thought it was a wiring issue with rubbing wiring on frame then thought it was crank sensor wires then it got worse and shut down completely with codes 33 34 35 sometimes just one would show up it...

nytro MTX gas milage! I really in my great great milage nytro one tank all season cause it just does not start and when it does i ALL WAYS COME HOME IN THE BACK oF A TRUCK I am going back to my polaris !

I am now getting error codes 33 34 35 machine will not strart sits for a while then starts ran fine is there a yamaha bulliten out for this

I have by passed my tors but nytro just about dies and light flashes with check engine light comes on for a scond then it resets itself before i can read code then runs fine sometimes is when i punch it and some times when i am just excellerating can i bring up past codes