Search results

lower ball joint So at first I assumed you put the washer between the lower ball joint and the spindle. This stopped the spindle from compressing the seal on the ball joint. But this didnt make sense because then there wasnt enough bolt on top of the spindle to put the nut on, plus it really...

Did anyones Zbroz front end kit come with instructions other than the note about the spacer? Is it self explanatory enough not to need instructions? What parts do you have to reuse from stock? bushings? What else? Thanks for your help!

Sliders for OFT 136 extensions I can't seem to find sliders that just fit of the shelf on the oft 136 extensions. I got 136 inch hyfax (SMA-8CW92-70-HP) and they were about 1.75 inches too short. I just got my hands on some XTX sliders that I am planning on trimming down, but does anyone have...

Hyfax source Hi all, I have a hyfax related questions as well. I am putting OFTs 136" rail extensions on my standard nytro. Anybody have a good place to look for slides to use on this? Should I just buy XTX OEM slides? Any other suggestions, aftermarket recommendations?

Ok, great. Thanks. Its my first track replacement on any sled ever, so I was following the service manual to a T, but I will just go ahead and leave it on there. I have read that you don't want to tighten these down when re-installing till after the chaincase side is all snugged up, is that...

I am doing a track replacement this summer and am working on getting the drive shaft out. Anyone know what size allen head is required for the set screw for the bearing on the clutch side? I want to borrow a long T-handle from work to make it easy, but I need to know what size to grab. I...

I am looking for help from someone who has installed the relocator. I am at the end, step 24 from the instructions. I am trying to figure out a way to loosen the jamb nut at the bottom of the steering relay rod. I can barely get my arm and a wrench down in there, and when I do there is no...

Anyone put an Ice Attack or Ice Ripper track on their shortie? Any suggestions, comments, negatives?? Thanks!

I want to take some preload of my front springs. It looks like there are two seperate nuts around the spring threads, but I can not get them to rotate independently. They seem to be locked together. I have tried blaster and having me and a buddy try and rotate them in opposite directions at...

I just got a handlebar riser for my 08 Nytro. It consists of a plate to bar adapter and a 4" riser (like 6-6.5 total inches). I was wondering for anyone who has put on a similar riser, did you need to extend the cable lengths on the throttle, brake, or anything else? Thanks!

Check out hartmaninc.com. Haven't used it, but they have tons of different track kits for different yamaha sleds.

tool kit Ok, I have obviously been misinformed. I bought my 08 nytro used from a private seller. He said that nothing came in the front pouch when he got it from the dealer. I asked my local dealer to verify that there are no tools that are supposed to come with the sled. They said that...

Is there a special tool that is needed to turn the locknut and spring seat on the gytr front shocks? If there is not a special tool, what standard tool do you all use to turn these? Also, when I do turn the locknut, the spring seat also moves with it. How do you seperate them, do you need two...