Search results

Drain the carburator bowls and use gasline antifreeze to make sure all the water is out of the system. Mine ran like that until I completely ran it out of gas and then drained the bowls and used fresh fuel. It would idle fine but then bog when applying the throttle.

Thanks Viper Dave and Steiner for the tip applying the hand brake the secondary came off no problem.

Tried to remove the 14mm bolt holding the secondary to the shaft. With the parking brake applied the bolt and shaft still turned. Am I missing something to remove that 14mm bolt?

Never have cleaned the carbs so I probably should do that sometime. I will try the Sea Foam first and see if it makes a difference. Just curious how much everyone is adding to their fuel per application? Thanks

Thanks Irv. My buddy has a RX1 and his seems ready after the light turns off and it almost seems like his idles at a higher rpm than mine. I agree with you as it runs great once it is warm so nothing to worry about. Thanks again

My 2007 RS Venture starts great. I am finding I have to wait another 5 to 10 minutes until I can move it without stalling after the warm-up light turns off. Is this normal? Is there an adjustment I need to make with to the carburators? It runs great after it is warmed up. Thanks

Yes that is right Irv I meant the skid. Once the skid is removed there is plenty of room to work.

The job can be done in a day. It does not take long to drop the track with just 4 bolts to remove. The seat takes a bit longer as lots of stuff on the rear seat to remove. Probably took me about 4 hours and this is my first time taking a snowmobile apart. Everything except the front brackets...

I just added tunnel protectors to my 2007 venture. Bought them from a dealer and they come with pretty good instructions. The holes are pre drilled in the tunnel and just have to rivet the protectors on. You must drop the track and take the seat off. The protectors from the dealer also...