Search results

Nice work

Can anyone teel me if all 4 stroke flex joints for nytros , Apexs, etc are the same and will work on a 2008 Nytro ?

I hear ya and agree .No start last weekend ,but this week every night fired right up. Go figure that out ???

new issue ,this short season .

I have had tight valves on one of my Attaks in the past at 12k miles but issue then was it would die after getting off the throttle when coming to a stop. It would start right up and run perfect tho. Troy at Donahue adjusted them and it runs great ever since . The winder has been a problem...

16.5k

Thanks for all the ideas. Now do I need a special gauge to determine fuel pressure or will an automotive one work ? Difficult to remove injectors?

Pump was changed last year. and it has a steady diet of Seafoam year round . Do I need a fuel pressure gauge to determine correct flow ?

Hard starting ,long cranking on my Sidewinder. Starts normal sometime other just cranks and nothing . Fresh fuel, new plugs , new battery new starter so far . Any ideas where to go from here besides the dealer ? Always run up to temp when it does start ,and runs normal after start-up. Help Please!!

I need to change out my starter on my 17 Winder . Question is if I remove oil filter without dropping the oil will I loose it all thru the filter ? I hate to dump oil that has 150 miles on it .

Probably a 1500.00 bill if you had to pay for it so You came out good in my opinion !!!

That SRX is TOTAL YAMI FOR SURE!!

Glad he is alright ! sled is Toast

let er rip . Just sand it smooth.

Looks to me someone trailered your sled without a cover also . I would wash it down good on a nice warm day and get some of the storage crud off it too! Congrats on your find .

Search this site for fixes if the supplier of the plates is still here ?

no , You need good rivets most likely with large heads and washers . My holes and rivets were holding nothing

very common . Mine separated and some one on this site sold me a support plate and was added to the ton of the tunnel . pretty thin material there . Lots of work .

Can you tell me the proper measurement for the shiming