Search results

I was able to pull the stock grips off but you can't use them with the RSI elements. The stock heating elements have a foam tape under them that builds up the diameter quite a bit and when you install them with the RSI elements they are way to big!

Is it possible to position the heating elements to be able to use the stock grips and rivet them back on?

If it was me I'd pull the seals on all of the bearings. Doesn't make sense to me to have one side sealed etc.

I have a question. Why would Yamaha put a sealed bearing in the cover if it's inside and oil bath?

Long story short. Stealer calls and says you have a bad wire. I'm like no s#$t! They say that they have to order a new wire harness and it won't be in until the end of March. I said no way and go pick it up. I try and trouble shoot some more and find the that the red \green wire from the fuse to...

Had to give up and take it to the stealer. They threw in a known good ECU and still no power to the fuel pump. They say it's a broken wire and have to replace the whole wire harness. Yikes. Get ready to bend over i guess

Installed new starter relay and SSR red relay for the fuel pump and still no power to fuel pump. If I bypass everything and run power direct to the fuel pump it runs. So I know it's not the pump being bad.

I got a 06' attak with no power to the fuel pump. Iv'e swapped relays and cleaned the electrical plug at the starter relay to no avail. Battery is new with a full charge. How can I rule out the main ECM? Thanks