Search results

2020 xtx-se

Sled has less than 800 miles . An make 20 lbs of boost an runs strong

Not yet? Any idea?

Hey there went through the tunes with td an install an found everything to be correct. Only thing we could think of is this sled when I bought it it had bikeman bov , instead of turbo smart bov, maybe the bikeman bov isn’t made to run more then 20 pounds of boost, when it sees any more then 20...

Don’t think so. If crack pressure is set to high would that result in under boost?

Ok thanks just doubled checked my crack pressure it was 13 2 pounds high . What would that affect?

So the tune says TD WG race 20 BT v4 . How do I know if the tunes for 3 bar or 4 bar ? Red a black wire goes to waste gate a black a green goes to bov .

No but I will try that an see if it helps yeah it’s a three bar. Everything came from td all tunes the new tunes for header a waste gate . Something else that’s weird in the 2 step I can only make like 3 pounds of boost an I got it set to 7 pounds really strange.

Any ideas on what it might be ? just seems something not right doubled an triple checked vac lines .

Iam about to throw electric waste gate in trash a just lock it . But like being able to trail ride as well with lower tunes.

Yeah Iam plugged in to the plug stock solenoid was plugged into. Doubled checked all 4 hoes there going to the right places. Only difference is instead of being vented to atmosphere Iam vented back to cold air intake. Can not figure this out. Unless it’s this stupid bike man bov an it’s letting...

Yes drilled out nipple port on turbo . Where are u supposed to get power from?

Yeah had it set to add 4 pounds, an it won’t go above 19. Even if I put in the race 30 tune it still makes only 19 seems like waste gate is not working correctly?

Yes installed last year an never been able to get it working properly. I’ll double check the vac lines. Is there any sort of electric that goes to solenoid? Any thing else to check? Thanks

Crack pressure is set to 11 which is td recommendeds . I have the waste gate multiples turned up to help make boost quicker which it’s not helping. Iam not sure what the boost slider is you’re talking about. Can u tell me more about that thanks.

Looking for some help with electronic waste gate. Can’t get sled to make more than 20 pounds of boost. No boost leaks, have allready machined spacers between clamps, an put boost leak tester on it serval times. Can easily get 27 pounds an more with no leaks. Even if I put in race 30 tune still...

Looking for some instructions on installing TD supercooler with fan searched an can’t seem to find anything? Thanks

Can anyone tell me why my offset is so far off ? Iam using Dave’s alignment bar to check. Just re did stub shaft thought that might be the issue didn’t help.

No have not measured offset cus Iam running the floating secondary now . Should I still measure the offset ? Iam running dalton weights in primary. Thanks

Yeah I just installed 911 cover an new primary spring as well something is definitely going on. The inside sheave gets super hot just letting sled idle?