Search results

Howdy! Looks like your reply was blank/empty.

Right on! Thanks for the feedback! Regarding the fuel pump, here's a little more context: I have two '07 Phazers--currently one runs, and one doesn't. It first stopped running after unloading from my trailer at the trailhead (physical jarring of a bad connector?). Found corrosion on the unsealed...

Hey Rockmeister, looking for any general advice on finding parts for my 07 Phazers. I have two, and just working on updating several things to keep them cruising. Any advice you have on wiring connectors, replacing handlebar guards, finding a replacement track, replacing or rebuilding the rear...

Right on, do you have a photo of your guide?

Hey Glockster35, what did you end up doing? Looks like I'm following in your footsteps--I've got two '07 Phazers that I need to replace the track on. What/where did you buy, what price, and how did the cutting go? Success?? Looking forward to hearing what lessons you learned. Thanks!

Thank you! Do you remember where you bought your replacement track?

Thank you! I'll check them out.

Appreciate it. I should have given a better explanation--I don't ride with 2, unless I'm just carrying someone here to there for some short reason. But the suspension can be compressed by hand easily on the trailer. It doesn't rebound on its own all the way. You feel it bottoming out on bumpy...

I'm cleaning up my 07 Phazers one little project at a time. Right now I'm chasing a fuel pump gremlin (see separate thread), and recently had my seats reupholstered (they look fantastic!), and improving other things here and there. I've been slowly building my own database of where to find...

Well just an update, it has been a week where I haven't been able to work on chasing my fuel pump wiring gremlin, but I will say that after jumping the fuel pump manually and running the sled for a few minutes until it dropped back to low idle, my code 81 is gone. Now I only have a red temp...

Hi Maim, I've got the yellow ground blocks on both of my 07 Phazers. How do you recommend I verify they are good? I opened up the small hatch and visually inspected plus tugged on each wire going into the bottom of each ground block but want to make sure I do this right. I'm still chasing a...

I'll need to try and find the starter solenoid to explore this. Unfortunately need to go work on a weather station today and will have to do that with a single sled! Better one than none!

When I jumped the fuel pump, I disconnected the plug at the fuel pump, and jumped directly from the battery to the pos/neg prongs at the top of fuel pump at the mounting point in the tank. Yeah the gauge pod thing was strange. Kill switch would not shut it off either. Pulled the key and still...

Really grateful for the input. After checking all the relays and fuses, I went through and disconnected almost all of the other plugs on the right side, added a little dielectric grease, reconnected. Disconnected both battery leads, then disconnected ECU plugs, things didn't look bad on any of...

Oh gotcha. So unplugged causes the code, then plugged in with some other problem in the circuit or warmer also causes a code? Is there any chance that whatever is causing this code 81 to flash is also preventing the fuel pump from operating? My fuel pump is fine, but it won't pump when key is...

Gotcha. Shouldn't that code disappear with both grip warmers disconnected?

I also cycled through the diagnostic code 26 (pushing grip warmer to initiate the 120 second test), and no change to the fault code 81...

How can I erase the memory? I've unplugged both grip warmers, and the code 81 still flashes. Checked all relays and fuses too, and still flashing.

Alright Mooseman, I forgot to reply yesterday but I traced the wiring to the plug for each grip warmer. Both sides show 1.8 ohms, which sounds like what is expected. I may try and unplug both, then power on the machine and see if that code 81 will clear? Also, I already have a manual but I am...

Right on Mooseman, I will do that and report back! Thanks!