2005 RX-1 Owners, need some help!!!!!

[Srxspec]

Guys, I'm looking to swap someone for their rear swing arm in the rear suspension. I need a stock one for the grass and need it quickly. I have one on order, but it's back ordered until October. The deal is simple, the part must be in good condition, not bent and with no cracked welds. When the new arm shows up I will ship it to you immediately to replace yours. The part number is 8FU-47332-00-00 and it's called "Arm, Pivot 2" and #28 on the parts image I've attached.

Allen

 

[Srxspec]

Ok, I'll throw in a stage III clutch kit at dealer cost for the guy who steps up on this deal.

 

[Mighty]

Ok, I'll throw in a stage III clutch kit at dealer cost for the guy who steps up on this deal.

Throw it in for free and I'll go steal you one 8)

 

[kenlacy]

If no one else can. I will, but you'll have to give me until after the weekend to get it out (Tuesday would be the first shippable day for me, can't ship on Monday because of the Holiday). I am gone for the next 4 days basically.

 

[Srxspec]

kenlacy, thank you, I will contact you via PM on Monday if no one else responds.

 

[hlmrx1]

srxspec, I have an older skid here, it's suppose to be from an srx, not sure what year. The only thing that looks different is the bushings (not sure if that the right name) on the ends that butt up to the mounting brackets, but you shouldn't need that part of it. I was going to use this skid for asphalt, and still might, but there was a lot of parts missing when I got it and I have used a few parts from it to put on my 03 skid in order to lower it. I think it's the same as my 03 but don't know if it would fit on the 05. Wish I knew what year this skid was from. Anyway I could maybe dig into it a little further or try and get some basic measurements if you want. When did you need this by? I go down to Moorhead once in a while to race, your in SD aren't you?

 

[LazyBastard]

There's no way that would fit on an 05.