stgdz
TY 4 Stroke Guru
- Joined
- Mar 27, 2021
- Messages
- 785
- Reaction score
- 374
- Points
- 478
- Location
- Buffalo MN
- Country
- USA
- Snowmobile
- 19 tcat, 15 4000 RR, 13 800 RR
Also if you really want a tight fit, use green loctite.
Good luck ever getting it off though.
Good luck ever getting it off though.
STAIN
Lifetime Member
- Joined
- Feb 29, 2004
- Messages
- 4,606
- Reaction score
- 3,856
- Points
- 1,713
- Location
- Vermont
- Country
- USA
- Snowmobile
- 2024 Arctic Cat Riot 9000
- LOCATION
- Vermont
I have used the factory wave rotor, but not the BDX rotors.
The factory rotor did not seem to chew pads up.
Pstn head
TY 4 Stroke Master
I’ve used green locktight, bearing didn’t spin, held perfectly… just be sure to to install calliper true to shaft, you do have a few minutes to accomplish this. To remove use a little heat inside the hollow of the shaft just under the bearing and with a puller the calliper should slide off. Keep an extinguisher close by just in case.