Apex Disassembly

[YammiMoose]

I spent some time taking apart my GT to get to know it better. I found the boot for the EFI not seated properly along with loose bolts holding the headlight on. I spent way too much time trying to get the clamps tight. I used a 5mm Allen key. It didn't have what I can only describe as a ball or rounded tip on the end to get it to seat properly in the bolt. I also found I couldn't find one long enough to make an easy job of it. Does anyone know how long were the ones used in the guide by Srxspec.

-5mm "T" handled Allen Wrench

Thanks!

 

[AIRWOLF]

I just ordered a set of metric T handle allen wrenches 9" long




http://www.amazon.com/gp/search/ref=xs_ ... 20wrenches

 

[YammiMoose]

I just ordered a set of metric T handle allen wrenches 10" long

I'll have to see where i ordered them from

The set I ended up buying had long ones until it got down to 6mm than after that they were all short ones.....
I saw two other sets over the weekend that were the same way.


Thanks....

 

[AIRWOLF]

just added a link check it out

http://www.amazon.com/gp/search/ref=xs_ ... 20wrenches

 

[AIRWOLF]

it looks like Allens are SK TOOLS

 

[AIRWOLF]

FOUND THEM !


http://www.toolsource.com/ost/product.a ... 5VNUWL2WF5

 

[vice108]

I just ordered a set of metric T handle allen wrenches 9" long




http://www.amazon.com/gp/search/ref=xs_ ... 20wrenches

I just ordered the same ones. Thanks for posting the link. 9 inches should be enough to get in there.

 

[BA APEX]

I bought the ones below off ebay was around $25 with shipping. not sure of exact lenth but they work fine. the 5mm is just long enough, i think it is about 150mm(6").