Are the ecp filters/kit similar to k/n or kickassfilters

[rx1forever]

Hi there this is my second post and not my last, so please bare with me in asking this dumb question, I have 2 04 rx1 mtns 66 an 65 miles so far is it to early for this upgrade do i still need to have them broken in? are these filters expensive, where can i get them? thanks for the help :lol:

 

[rxrider]

Welcome on board rx1forever.

Just install them and continue your preffered way of brakeing in your sleds. Some like it hard others goes by the book when it comes to break in procedures.

Prices for parts kit includes.
All funds are in U.S. currency:
Filters $98.95
Jets $10.00 (4)
Crankcase vent filter $24.95
NGK CR10EK sparkplugs $31.80 (4)
Silver CV slide springs $35.00 (this is what we had best results with..not required though)
Pre Filters $37.90 (only needed for snow powdery conditions)

You can get the filter kit from Freddie Klies at Easter Cycle Performance, send an email to KliesECP@aol.com

 

[RobX-1]

The ECP filter kit actually uses K&N filters. I think the complete kit cost around $250 which includes two filters, pre-filters, carb springs, 4 jets, crankcase filter, and 4 NGK plugs. Although his website does not have info regarding his kit, it does have his contact info. Not sure about installing them with low miles although I couldn't see why you couldn't.

http://www.easterncycleperf.com/

 

[rx1forever]

thanks for the info guys i will contact him shortly :wink: