Belt deflection hardware

[turbine tester]

Hey all, should I be swapping these belt deflection bolts out? The tip are worn with rolled over material, I am not sure how much of a nub should be on the bolt. Also can I flip the contact plate over that bolts to the clutch as it has some wear also where the bolts contact (about .004-.005). I am trying to get my new belt to stop squealing, the shim on the bolts measures .039. Looks like there is only two sizes of shims .050 and 1.00 so not sure where the .039 came from. If my bolts are worn this could be causing my squeal as the washers are thin already.

 

[steiner]

Remove the washers under the three bolts. When the belt starts riding low in the secondary reinstall the washers.

 

[TBay Sledhead]

Yes you can turn the plate over, I did mine and OK. Time to replace the bolts.

 

[Shootis]

I measured old and new bolts in this thread:

http://ty4stroke.com/threads/setting-belt-deflection-tip.147366/#post-1357561