Bender stage 1 fuel lines installation?

[Jabakanada]

Hi everybody. I´m new in this forum and I have just bought -04 RX Warrior with little modified Bender stage 1 kit. engine haves two head shims and 400mj (hi-boost) at the pitot tube. Running now @ 12 PSI and little too rich fuel/air mixture (seen it from sparplugs).

Could somebody send me instruction pics or manual or something that could help me understand those fuel lines and carb pressurising. Previous owner said that sled haves different fuel pump or pressure regulator than original Bender kit pump. Biggest problem I have with on/off -valves on fuel lines??? theres only one on/off valve and I think that it is in wrong place. Another one have been replaced with Y-pipe and fuel-pressure gauge.

Little confused..... (first snow came yesterday 5 inches)

- Jaba

 

[TT]

Jaba send me a pm with your e-mail - and I will e-mail you the Bender stage 2 install manual.

If you check out the link under my signatur you will see quite a few pics of a Bender stage 2 kit installed.

 

[Jabakanada]

Thanks a lot. Your project pics really helped me. Looks like I have modified fuel lines. Well.....to the garage.