Grassfirebob
Pro
I blew a belt recently and couldn't get all the scraps out of the secondary. New belt squeals at idle so I thought the secondary just wasn't closing. Anyway, I took the helix off my secondary today to I could easily open up the secondary and clean it. Problem is it got away from me and shot off before I could note which holes the (pink) spring was in.
It's a stock '05 RS Venture, midwest altitude.
Anyone know the factory settings the spring goes into? (0,3,6, or 9 on the helix), and which hole on the secondary?
THANKS!
Bob
It's a stock '05 RS Venture, midwest altitude.
Anyone know the factory settings the spring goes into? (0,3,6, or 9 on the helix), and which hole on the secondary?
THANKS!
Bob
- Joined
- Jun 28, 2004
- Messages
- 2,436
- Age
- 64
- Location
- Clinton, Wi.
- Country
- USA
- Snowmobile
- '11 Apex XTX, '09 Venture GT, '06 Attak, 08 Nytro Hybrid
Manual says 3-3 for USA/Canada or 6-1 for European models. Try either and it'll be good. Lower # will have faster upshift and slower backshift, opposite with the other
Grassfirebob
Pro
Thanks Dave! Once again you've got my back ;-)
- Joined
- Jun 28, 2004
- Messages
- 2,436
- Age
- 64
- Location
- Clinton, Wi.
- Country
- USA
- Snowmobile
- '11 Apex XTX, '09 Venture GT, '06 Attak, 08 Nytro Hybrid
Yes sir Dave is right 60 degrees is the setting for your secondary spring.
Dave who snapped that picture as you were falling over on your sled? lol
Dave who snapped that picture as you were falling over on your sled? lol
- Joined
- Jun 28, 2004
- Messages
- 2,436
- Age
- 64
- Location
- Clinton, Wi.
- Country
- USA
- Snowmobile
- '11 Apex XTX, '09 Venture GT, '06 Attak, 08 Nytro Hybrid
Frame capture from Dobson Entertainment video. And, uh, yeah, I DID fall over right after that LOL!!
