Need apex mtn suspension mounting measurements.

[mountain_mod_viper]

I'm mounting an apex mnt suspension in a viper and would like to get some measurements from the driveshaft to the front mounting shaft. Then center to center from the front to rear mount, and how far down from top of tunnel. This question is for those of you who have changed tunnels and have a stock tunnel with nothing mounted in it to get an accurate measurement.

When taking measurements, use a square from the top of the tunnel to the center of hole

Thanks

 

[pro116]

specs

If you can wait about 3 weeks I can get it for you I just put my suspension and a different back in two nights ago.

 

[Apex]

I'm mounting an apex mnt suspension in a viper and would like to get some measurements from the driveshaft to the front mounting shaft. Then center to center from the front to rear mount, and how far down from top of tunnel. This question is for those of you who have changed tunnels and have a stock tunnel with nothing mounted in it to get an accurate measurement.

When taking measurements, use a square from the top of the tunnel to the center of hole

Thanks

I can give what it take for a fab-craft. They are dam close to stock I only had to move the hole up a 1/2 inch from stock. 162 skid. That would only help your aproach angle.

I will have to find the papers, let me know if you need them.