Set up for 14.5 rollers

[mopar yam]

Just picked up a 09 rtx se 121 and already have a set of 14.5 rollers does anyone have a good set up for it , springs helix etc ? Thanks

 

[canoehead]

I run with a set of 2-speed weights, Yowsers hold on tight!!

 

[mopar yam]

I'd like to use the stock weights if possible ! Low buck performance !

 

[baggs66]

Ypy primary spring drill out rivet in tip of weight 45/39 helix and your 14.5 rollers, will give you smooth bottom end and pull hard try it you'll like it

 

[toyota4runner]

What would happen if you just changed the rollers and nothing else?

 

[baggs66]

It will engage a little lower and your peak rpms will be lower. The smaller rollers will load your clutches harder, you may be able to just use rollers and take the tip rivet out to get your rpms back on top. The pink rate spring will lower your engagement more and make it nice and smooth to ride at low speed their only about $20, you may want to try rollers and remove rivet 1st to see what your peak rpms are, if their low then you would want a higher shift rate on the spring

 

[09nytro]

If you don't mind me asking , What did you pay for it ?

 

[mopar yam]

For the nytro $5800 from a dealer up here with 6000 kms or approx 4000 miles , very clean one owner 96 studs , may add more and some tuners skis . Oh ya it came with blue low windshield and a medium with deflectors too ! Anymore ideas on the clutches would be great guys .Thanks !

 

[mopar yam]

So do you keep the secondary spring stock or does it have to be changed too ?

 

[nor'easter]

I would call Chris Schmidt at Schmidt Brothers Motorsports. He is a site sponsor. He is an expert in nytro clutch set-ups, and he also sells components for the clutch that you ask about.

 

[baggs66]

I think that setup has stock pink secondary but I would have to look it's in my sisters sled, I do use the silver secondary spring most of the time .

 

[baggs66]

We have a Schmidt kit kit in a friends xtx it works well but I think way to expensive for what u get I think almost $400, for$100 for a spring an helix you will be happy and I think it pulls harder than the Schmidt set-up

 

[nytro11tom]

ypy spring 14.5 rollers tighten secondary one hole