Some questions about jack and driveshaft bearinngs.

[YammyRX1]

Lots of info in these posts:

http://www.ty4stroke.com/viewtopic.php?t=52677

http://www.totallyamaha.com/snowmobiles/aaTECH/Jackshaftreplace/Jackshaftchange.htm

http://www.ty4stroke.com/threads/driveshaft-bearing-numbers.77281/

 

[straycat03rx1]

I found out you cant use the cam locking bearings used on cat and polaris track drive shaft. I went to lock down the bear and couldn't move the locking caller. you would have to machine the non drive side of the shaft to relieve the bearing. Plus the bearing fit isn't near as good as the yami bearing.

 

[Tommyboy]

I found out you cant use the cam locking bearings used on cat and polaris track drive shaft. I went to lock down the bear and couldn't move the locking caller. you would have to machine the non drive side of the shaft to relieve the bearing. Plus the bearing fit isn't near as good as the yami bearing.

Thanks

 

[Tommyboy]

Lots of info in these posts:

http://www.ty4stroke.com/viewtopic.php?t=52677

http://www.totallyamaha.com/snowmobiles/aaTECH/Jackshaftreplace/Jackshaftchange.htm

http://www.ty4stroke.com/threads/driveshaft-bearing-numbers.77281/

Thanks for the info, I tried searching but none of this came up. Cheers