Torque specs for primary and secondary?

[ZR800EFI]

Can someone please give me the torque specs for the Apex? Just in case it's not in the manual when I get home...

Thanks!

 

[ROCKERDAN]

not sure,but i can tell you the primary bolt is MUCH MORE STOUT then a DOO primary bolt,which have been breaking upon 89ft lbs....

SO IMO you can easily put 75-80 ft lbs without any worries...I alway recommend ANTI SEIZE for bolt threads where they go into crank.

Dan

 

[ZR800EFI]

75-80lbs??? For some reason, I thought more like 55-60, then run and re-torque? Is that not enough?

 

[BOUNTYHUNTER]

Primary.....1st Set at 112 FT LBS........loosen reset to 43 FT LBS.

Primary cover 6 bolts 10 FT LBS EACH

Secondary......46 FT LBS / Helix nuts 17 FT LBS.

 

[ZR800EFI]

Cool, thanks guys!
Didn't realize it was that much...glad I asked.

 

[grader]

WRONG THE PRIMARY TORQUE IS 80-85, NOT 112. this is a missprint in the manual and could break the bolt.

 

[progas]

torque it first to 85, then back it off and re-torque it to 42. Thats the primary clutch bolt.

 

[ZR800EFI]

Thanks, that sounds a bit better!

 

[ROCKERDAN]

never go over 85....your asking for trouble with galling if you do...trust me.


Dan

 

[BOUNTYHUNTER]

trouble with galling if you do...trust me.


Dan

WHAT's GALLING?


Funny I never hear of any misprint, Tk's..... I'll be sure to check on it today. Set lots at that & never seen any problems.

 

[BOUNTYHUNTER]

Yep you were ABSOLUTELY CORRECT


85ft lbs 1st then 43 ft lbs


There are a wack of 04/05/06's Running around that I did TOO TIGHT I guess, THANKS FOR THE TIP. ...........That Embarassing to have done that...........OOOPS



Funnny I took Mine off today and check everything looks perfectly ok.......Phew