Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
We are no longer supporting TapaTalk as a mobile app for our sites. The TapaTalk App has many issues with speed on our server as well as security holes that leave us vulnerable to attacks and spammers.
Not sure if this is a common problem but i just bought this sled and i found that both of them have hair line cracks right behind the bracket for the rear skid.... anyone else had this problem and know how to fix them or make sure this does not happen again? IMO this is a poor design to reduce...
Well first i decided to change oil..... should have looked at that when i bought the sled it looks like chocolate milk and both coolant tanks are empty fml.... changed it. Found the rattle.... bad doughnuts changed them.... btw the front bolts for the y pipes on the tunnel stripped out and the...
Well i used a WIX filter and mobile one.... i will let you guys know if it blows up. Always worked in the Rx1 but whoever had this sled before me obviously didnt change the oil often it looks like chocolate milk seriously..... kinda upset about it.
Thanks guys that helped out a lot, Is my skid the same as the 07 because i see people complain about it and say get rid of it..... do i need to do anything like that? And what about those anti ratchet drives everyopne talkes about?
Sled has 2800 miles on it what are some things i should look for or change? i want to do an exhaust because i can here a rattle comming from it and if i do that should i run a fueling box if so what one? cluch kit? I have owned 2 rx1's and i expected it to be close but nothing is the same. If...
#2 carb from clutch side has been giving me alot of problems. when i bought the sled that plug was fowled changed plugs noticed fuel pouriung out the over flow from 1+2 carbs. found a small burr in the brass piece that the needel float valve rides in. i took fine grit sand paper got the burr out...
the tors was sticking at the thumb throttle. so i took the thumb throttle apart, cleaned the nylon bushings and the pin, sprayed it with sylicone spray and ran perfectly fine so that was an easy fix. thanks everyone.
i did clean it 2x just incase. i did have a needle stuck for my float the first time because i got a burr in the little brass plug with the filter. any ideas how the tors works? i feel like its that because it wont rev up and if you work the throttle all it does is shoot flames out the exhaust...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.