Recent content by Algonquin Rider

  1. A

    2011 Apex SE Dreaded Code 11

    I ended up disconnecting the battery and it reset the code. All good with over 150 miles on it.
  2. A

    2011 Apex SE Dreaded Code 11

    I did change that. Its called the Cam Position Sensor ($200). Still have Code 11. Following the plug into the wiring harness there are 2 grounding blocks. One has 6 Blue wires and am getting 300-400 Ohms. The other with 6 Black/Blue wires I get 0 Ohms. Checking all the other grounding blocks I...
  3. A

    2011 Apex SE Dreaded Code 11

    So I have been fighting with an intermittent Code 11. It will run fine and start no problem. Sometimes Code 11 will pop up while it's running. I head home. Turn it off and says Code 11 and won't start. Went through the manual. Check load test on battery, starter solenoid, tested all 4 relays and...
  4. A

    Jack Shaft Lock Nut Loose?

    So is it All Balls or KML? I re-pack the bearing every yesr.
  5. A

    Jack Shaft Lock Nut Loose?

    So is it All Balls or KML?
  6. A

    Jack Shaft Lock Nut Loose?

    Here are a couple pictures from the other side. The split collar is pulled back in the inner race about 1/8". I have had this sled for 10 years and never touched this aside from tr-packingthe bearing grease. Should I try to loosen the nut and reset the split collar then tighten or leave it? The...
  7. A

    Jack Shaft Lock Nut Loose?

    So I noticed my jack shaft lock nut has some exposed threads. It looks like its not tight but it is. I can move it slightly by hitting it with a screwdriver and hammer so its not seized. There was no issues with noise or vibration and no movement in the shaft side to side. Noticed it checking my...
  8. A

    2006 Apex Cooling Fan no Worky

    Fuse is good, put power to the fan and it runs. There must be a relay somewhere? Any ideas where? Thanks
  9. A

    Brand new Apex -31c won't start , I got left behind..:(

    Great, thanks. So as long as there is a decent warm up, it should not be an issue?
  10. A

    Brand new Apex -31c won't start , I got left behind..:(

    Block Heater Location on an Apex I got a block heater for my Apex. What is the proper location to put it? Can it go on the hose next to the oil tank? Thanks in advance.
  11. A

    2007 Kodiak Not Running Good

    Found the problem. A piece of crud in the main jet. Blew out and runs like a top. :Rockon:
  12. A

    2007 Kodiak Not Running Good

    Thanks for the info. Cap was off the tank so that eliminates the vent tube. Took the petcock apart and flows plenty. Will pull off the carb tomorrow.
  13. A

    2007 Kodiak Not Running Good

    Hey Guy's, 2007 Kodiak 350 IRS 8,200km Was running down a road about 50km and the motor quit like it was out of gas. As I was slowing down I switched to reserve. Was sputtering but when gave it any throttle it would stall. The tank is full. Tried starting and it would start but as...
  14. A

    rev limiter

    Read this. http://www.tyatv.com/viewtopic.php?t=1501&highlight=
  15. A

    Flashing Reverse Light on 350 Kodiak

    My reverse light blinks all the time now. Speedo also does not work. I read that it is the speed sensor but can't find where it is or the part number. Any help? Thanks Ended up being the speedo cable. Problem solved, only $6.25 for the cable. :Rockon:


Back
Top