Recent content by aquaticlaker

This should work also.

.

.

GYZ20H

You are correct! My mistake

Looking for some help! 2018 sidewinder with Turbo Dynamic flashes, 3 bar map sensor, blow off valve, CAI, sock muffler. I have a P1236 error. I have researched on this site and have done the following. Boost tested system and tights clamps, boost holds well. Attached is the boost and boost map...

2018 LTX sidewinder with 8k miles. Thought I would check the boost pressure sense I have not for 6k. Prior to test I found that all clamps need tightening. Then I made a tester as seen in the photo. Soap tested and tightened where needed. Does the slow bleed off seem normal? I could not find...

Just replaced my shaft and the shaft was not a slip fit. Shaft could have been better fit. 7000 mile

No I did not

Did you try this battery?

Thank you!

When taking the gearbox apart I forgot how the bushing and spring went together! I looked at the track drive drawing but that seams wrong or I don’t get it. Is the photo assembled correctly?

Pm me your address and I will send it out tomorrow

I have the tester and am done with it. No major leaks here. Who is next on the list?

It’s headed my way soon then I’ll get it out to next person