Recent content by herndonp

2012 XTX with curves toe out set at 1/2" Pete

Here is one on ebay for a Nytro https://www.ebay.com/itm/Kimpex-Snowmobile-Removable-Passenger-Seat-Jack-Yamaha-Nytro-1050-2008-to-2014/202560489798?hash=item2f298bc946:g:RlIAAOSwVNNcNIId:rk:13:pf:0

Check the fuel pump flange on tank mine leaked there. If its leaking there pull pump and use some permatex or silicone gasket maker that is fuel resistant and let it sit overnight before using. Pete

Got about a foot in our area, but trails aren't allowed to be ridden on until Dec 15. There are a few places to go if you want to drive a ways, but usually all beat up as they are not groomed. 2 more weeks and hopefully we get a good dumping. Pete

This is what I have been using and have had no problems for the past 5 years. I use a 1/4 x 20 stainless steel hex bolt with them. Put a little anti-sieze on the bolts...

50/50 good to around -34 DegF 60/40 good to around -60 DegF I use the recommended 60/40 here in New Hampshire Pete

If your use to the handling of a ZR!! or F7 you most definitely will be disappointed. You might look for a used Viper you get the Nytro engine in a Cat with Yamaha clutches etc. Here is one in NY https://nh.craigslist.org/snd/d/2015-yamaha-sr-viper-srviper/6741983145.html Pete

Use an Impact to pull the 4 bolts or you will fight the shaft turning to get the second bolt out on each side. Release the rear springs by lifting up and moving the plastic guide towards the front of the sled and lifting the spring up and over the idler wheel. Take your time and massage the...

Look at suspensions in the FAQ section at the top of this forum. Pete

What are you measuring for voltage across battery terminals? Have you been putting it on a charger every couple of months to maintain it. Mine still cranks her over and holds its voltage (2012). Put a good charge on it and let it sit for a couple of hours and check battery voltage if you got...

I would highly recommend putting a OFT steering relocate on it if it doesn't have one. Makes a big difference in steering and one of the best upgrades I did. Check all your idler wheel bearings and replace (I replaced 6 this year and have about 6,200 miles on mine). Check the clutchside...

I would highly recommend putting a OFT steering relocate on it if it doesn't have one. Makes a big difference in steering and one of the best upgrades I did. Check all your idler wheel bearings and replace (I replaced 6 this year and have about 6,200 miles on mine). Check the clutchside...

I have the 2012 and grips are fine. Very rarely turn them all the way up except when below 0 deg F. Then up initially then back off alittle. Pete

If you come up with a solution share with us with some pics. Pete

Ok so it's part of the block where cable is held down in block by this clip. Do you have a friend who has same machine you could see this clip and possibly just make one. Otherwise if it's anything like BMW you have to buy the whole block. Which I agree is stupid!! Pete