Recent content by Joe Dugdale

Put a stud through front heat exchanger on the weekend. Going to have it tig welded this week. In order to make access easier, the welder is going to tip it on its side to access the crack on the bottom of the exchanger. Do I need to drain engine oil prior to tipping it up, or will it...

Thanks for the help.. Any chance you know offhand what the specific voltage should be for that sensor? I've read various different specs online.

Original sensor quit, faulted out.. Replaced with new.. High and fast idle now is off, as well as its stepping down off high idle before up to temp

Attached a screenshot of the tps adjustment

Any quick tips on setting up a tps sensor on 05 rx1? Have the service manual....not really understanding the steps

Thanks... I have continuity from the harness plug to the thumbwarmer....both wires

have 13.8 volts to both wires at thumbwarmer switch plug when idling, switch works as it should when I plug it into handwarmer, it controls them fine......

Hey fellas, got an issue with my rx1 thumbwarmer... Seems like it goes to full power, or high and cannot be adjusted...so hot, it can barely be used... When trying to adjust on handlebar control, I don't even get a readout on the display... Did some reading, and thought it was cdi related...

Any fix for this, seeing same thing myself..

I have 13.8 volts to both wires at thumbwarmer switch plug when idling, switch works as it should when I plug it into handwarmer, it controls them fine......

Hey fellas, got an issue with my rx1 thumbwarmer... Seems like it goes to full power, or high and cannot be adjusted...so hot, it can barely be used... When trying to adjust on handlebar control, I don't even get a readout on the display... Did some reading, and thought it was cdi...

thank you sir

Muffler/silencer pipe was cooked on my o5 rx1, bought new headers and silencer off of ebay, i was told they were stainless headers from an 03. When package arrived, these are what came with it. about 3 inches longer than my pipe(top one) obviously not stainless either. My headrers were fine...

Control rod in my 2005 mono skid is shot, can i replace it with a bender rod i have from my old proaction suspension?