• We are no longer supporting TapaTalk as a mobile app for our sites. The TapaTalk App has many issues with speed on our server as well as security holes that leave us vulnerable to attacks and spammers.

Recent content by smallheadz

  1. smallheadz

    Rx1 Oil pan - 2003

    two different part number = 1 is the old one, 1 is the new one. Agree with above Check with Travis, he ships to Canada too.
  2. smallheadz

    Rx1 Oil pan - 2003

    I believe they are all the same from 03-17 according to the part numbers. Looks like a used one will run you $25-$50 8FA-13417-00-00, 8FA-13417-01-00
  3. smallheadz

    2003 RX-1ER no top end mid range stumble

    no just all the same , tons of videos on youtube. Motorcycles are done the same way as well.
  4. smallheadz

    Help!! Side covers for side panels

    Sometimes it takes a day or so for him to reply to a text. There are a couple on ebay too.
  5. smallheadz

    2003 RX-1ER no top end mid range stumble

    basically all you are doing is making sure they all have the same vacuum. If you are going to keep the sled or work on any carb stuff then I would purchase a set. They hook to the nipples on the intake boots. The carbs adjust by phillips screws on the linkage inbetween 1-2, 23,3-4. So there are...
  6. smallheadz

    2003 RX-1ER no top end mid range stumble

    Factory is 2 turns out, a lot of people run them at 2.5 . I myself run at 2.25 turns out. Make sure you sync carbs when done. Also make sure your pilot jets are clean, they are tiny 17.5 and plug easy. I keep a spare set clean at all times and change out any time I have the carbs off. Cleaned...
  7. smallheadz

    Help!! Side covers for side panels

    Call Travis at Barn of Parts
  8. smallheadz

    2003 RX-1ER no top end mid range stumble

    Yea 6000 is way low. Have you had the carbs off? There are screens under the needle/seat that can plug too. My guess carb related, make sure you sync them after you clean them.
  9. smallheadz

    2003 RX-1ER no top end mid range stumble

    the back shift on the clutch is normal and some of them will whine too. There are some youtube videos you can see and hear it. Pull the rubber from the top of the coils and start it in the dark to see if spark is jumping in the cylinder. Some people have wrapped them in electrical tape or use...
  10. smallheadz

    03 rx1 lean condition...?

    with 135 mains in mine my plugs were white, you are fine check after a good day of riding if you are worried about it
  11. smallheadz

    2003 RX-1ER no top end mid range stumble

    10200-10400 rpms, start with cleaning carbs. With only 1k miles and 17 years old it could be lots of things depending on where the sled was stored. Carbs, bearings froze, clutch, coils, plugs, etc...If in doubt clean the carbs twice. 03 coils were notorious for arching
  12. smallheadz

    03 rx1 lean condition...?

    agree with above. These tend to run lean from the get go but they don't seem to mind too much. Some people (me included) went with 137.5 mains, if you are running a stock airbox. I pull my plugs after several hours riding or at least normal operating temp and a long WOT run. Altitude plays a...
  13. smallheadz

    What's an ECP kit worth?

    will send you a pm
  14. smallheadz

    What's an ECP kit worth?

    true that, maybe once I get all my extra stuff dug out I will post up and see, only collecting dust in garage.
  15. smallheadz

    What's an ECP kit worth?

    Just want to know what an ECP kit is worth? Filters and prefilters, 165 mains, clean set of pilots, used cr10e, silver slide springs, and the small case filter. Just gathering all the old stuff out of the garage and may throw it up on the classifieds . Thanks


Back
Top