Search results

I think its 11's and 12's that have the new higher wattage stator. Not sure about the warmers. My warmers always worked great until I added all the other electronics.

I've seen on the spec sheets that the new Apex has an more powerful stator/charging system. Does anyone know if it will fit on an 07 Apex? I have too many electronics and when they are all running my grips wont warm up and my heated shield barely works. I also have a gps, rider warning lights...

Anyone? No one?

www.ledpowersports.com for all the led kits.

My 07 Apex with multi color LED's and underglow kit

Woody's duelies made a huge difference on my 07 Apex.

WOW, I didn't see that post. Added to my favorites now. I can't believe that yamaha doesn't have a grease fitting on these though. thanks

Anyone buy and install the yamahafactory phazer graphics kit? No instructions or pics as to where each piece goes. Some are obvious but others seem like they could go in multiple places. I searched and it seems if anyone here bought it they haven't posted pics. part number is...

what about drive shaft and jackshaft bearings? I cannot find any grease fittings for these anywhere. Are they sealed bearings? Thanks again.

thanks, thats what I have been doing but I was afraid I was missing something important. I was always told never to even think the word grease when touching the clutch.

OK I searched the forum but found nothing. The service manual says to lube the clutch but I cannot find anything about where and how? Are there other important lube points besides the suspension I'm missing? I missed the driveshaft bearing on my daughters polaris and blew the bearing out...

Just curious what the changes were to the body style from 07 to later years. My wife wants a decal set for her "new" 07 but some are listed to fit 08 and up but all the pics I see of phazers they all seem to look the same. Any ideas? thanks. Hoping she likes this better than her 03 RX-1.

I'm not sure about how they work on a phazer but on my wife's RX-1 and my Apex they made a huge difference. Darting almost gone completely and they actually go where you point them.

reverse doesn't seem to work now? In the process of doing this mod now and it seems the reverse isn't throwing the lever far enough. I moved both pivot pionts back about 3/4" of an inch. Anyone else having this problem?

I did change it to a 50/50 mix of coolant and distilled water. I also added water wetter.

The trails were a mix of packed and loose snow. not much ice. It did seem to run better when the cooler was first added but I can't remember. This is my wife's sled but it was real bad this past weekend. I drove it back on out trip. symtooms were that a couple of minutes after restarting...

I know this has been beat to death and I've searched all the old posts. I've checked the coolant and yes it was almost pure coolant. I've tried to bleed it but not sure if I did it right. I have the back of the sled on a stand but is that high enough? How can I be sure all the air is out? I...