Search results

Hi Guys, So, I went out this morning and tried a few more things. I checked the diagnostic for the air intake sensor and it was reading the outside air temperature perfectly to what the weather was doing prior to touching anything. I tried swapping ignition coils around without any luck. It...

Hi MooseMan, Thanks for the reply. The sled has 7000 kms on it now. It shows codes for the air intake sensor, oil sensor, TORS, and reverse open circuit. As you mentioned before, I think some of the codes are from the past and im not sure how to delete the prior codes but I actually...

Hi Guys, I am having issues starting my 2008 venture MP. I purchased it this fall and it was running Ok the first couple trips. I parked it, and the next time I went to use it, it wouldn't start. I replaced the spark plugs and it fired up with ease. I took it out to the lake, it started...

Thanks moose! Are you ever in Thunder Bay?

Thanks for the link for the coil. I will definitely pick up a starter relay too. Do you know which relay that one is? I had a hard time finding a diagram. On my machine there is an upper and lower level of relays. Two Of mine have been previously replaced with the red solid state relays...

Awesome! I’m Glad you got your machine going. I was fortunate as well and got mine running. The previous owner said he had done plugs last year but I’ll call bullshit on that haha In the end my plugs were ridiculously bad. Cleaned the terminal area for the coils with some electrical spray...

Thanks MooseMan! In my case, I went into diagnostic mode and found that I have codes 22(intake temp sensor or circuit), 30(oil pressure sensor),84(TORS), and 88(short or open circuit in reverse indicator switch) I tested both the ignition coils in the system test and the machine back fired...

Hi Guys, I am new to the forum so thanks in advance for any help you might be able to offer based on your experience. I recently purchased a 2008 Yamaha venture 500 multi purpose. The first couple trips seemed fine but I went to start my machine and I am having some issues. As a back story...