Search results

I'm still at a stock tune. I tried a Dalton black orange wrapped at 6-2 this year with new secondary rollers. I have a set of the qay66 coming and a black bronze primary spring. I'll try them empty to see what I get on a Hillclimb I like that I can adjust on the hill if I'm reving to high. I...

What clutching are you running now?

How are you liking the hurricane 270 tune?

Ok, thanks for the feedback. I might get the qay66 and run it on the stock tune for see how it feels.

Has anyone ran different brands of clutch weights Looking for feedback on clutch weights that people use in the mountains. Looking at a 270hp tune and would like real world feedback of mountain riding performance. I've searched the forums but couldn't find good comparison between the profiles...

I'm looking at getting a tune, which tune did you go with and how do you like it vs stock in the mountains?

What tune did you end up going with and how do you like it?

Ok thanks. Just felt like my sled was reving higher. I have 1300km on it in the mountains with the factory at 3-1 and no belt issues and seemed to preform good. I'm hoping it doesn't run too hot.

Isn't Dalton's recommendation of 6-2 is for the sleds that come factory at 3-3? I'm just curious if all mountain sleds came clocked at 3-1 instead of 3-3 or if it changed after 2017.

Do all of the Sidewinder mtx 163 have their secondaries clocked at 3-1 stock? The 2017 service manual says it's 3-1. I'm trying to figure out where to try the Dalton orange spring. Other models are 3-3 so the 6-2 recommendation from Dalton is close to stock.

Ok thank you. I threw it back together. I'll check for wear in the spring

Maybe the videos not that good. I was trying to show how much the gear can "wiggle" on the shaft. It's hard to see in the video so it must not be that bad.

Perfect. Would you mind taking a look at the video and tell me what you think?

New Dmc gear play on sidewinder

that's the old gear

Mines a good one, I made sure before I installed it.

Hey everyone. I have a 2017 sidewinder mtx and just installed the dmc top gear and found there is some side to side play and back a forth. The sled has 600 miles on it and this was purely preventative. Have you guys found there's a but of play with the gears you've installed. The shaft looks...

Can somebody that has installed a rogue concepts full support on a sidewinder comment on how much of the running board needed to come of to get it on? Thanks.

I'm thinking of getting a rogue concepts for my sidewinder and was wondering how much of the running board support needed to be removed to install? Do we have to remove the whole support or does the small back section attached to the tunnel come off on its own? Thanks