Search results

Need some help guys. I have a blown up 2008 phazer and I bought a good 2010 engine without the stator side. Can any of you tell me what this wire is? I have not found where the manual references it. Thank you Lee

I have been getting the Phazer ready for the season and it has developed a very large stumble between 6000 and 8000 RPMS. I have done the typical things such as drain the fuel and replaced with fresh. Also checked plugs and added some seafoam. None of which seemed to help at all. I searched...

I am getting close to firing the boat for the first time with the nytro motor. What weight oil should i be using for summer in this engine? I looked in the service manual but the range stops at 60 degrees F and only has 0W-30. Any thoughts? Thanks Lee

Taking the Nytro for a trip west. I have done a lot of searching on the site for a drag n fly clutch setup at elevation but have found nothing. I am currently running Turks black spring setup and it seems to be spot on. Anybody have a setup to share before I spend trip time tuning? Thanks...

So now that the Nytro is about finished for the next season, it is time to start this winters project: a mini aluminum hull jet boat powered by my 09 nytro motor. Over the summer i have slowly been gathering parts and tools to get started. The pump is out of a yamaha gp 1200 jet ski...

I picked this sled up from Seth (yam177) this past August and have been slowly working on it since. I'm going thought the entire sled replacing what is needed, since racing tends to be a bit hard on things. Here is what it started life as: Here's how it looked once i got it...

I have been on this site for a few months and finally got all me parts to start on my track conversion. So here is the start. For the track cutting i removed the legs from the table saw and ancored it to two saw horses. This was done with a large rachet strap and two c-clamps. I then...